Jeep Renegade SRS reset please?

[tarassych]

Hey guys, here's my srs dump from Jeep Renegade
Bosch 0 285 013 269

Can somebody help me to clean it up?
Many thanks in advance!

[dragon100]

Did you try clear via diagnostic ?

[tarassych]

no, I thought it's not possible...

btw, when I read a chip I got that messages, should I worry about it ?

[slick_dick]

no, I thought it's not possible...

btw, when I read a chip I got that messages, should I worry about it ?

clean the eeprom and read again

[tarassych]

sorry, i'm kinda new in chip flashing
some my questions must be looking stupid :)

is that correct ?
click on Blank, then Yes to All
then click on Read again ?

[slick_dick]

read and verify only, if you hit blank it will blank the eeprom and if you have not saved the original reading then this could cause issues

[tarassych]

ok I just was able to read it without any notifications,
the file in first post is updated to latest

[slick_dick]

your file leared

test and report

pass in pm

good luck

slick :tears_of_joy:

[tarassych]

thank you
just flashed it and tried on car - the airbag error still on dash...
looks like nothing changed

[slick_dick]

use a diagnotic tool, to clear errors in system. If any error fault remain repair them or post here we will help

[tarassych]

ok will try and report

[tarassych]

hey, I'm still waiting for "grey" cable to read SRS errors with AlfaOBD
but suddenly new error appeared - B1080 - Occupant Restraint Control, Fire Protection Strategy Failure - Signal Invalid
and got Fuel Cut Off message on dash
is it somehow related to SRS computer I flashed? any ideas?

** car still start and running well, just error on dash...

[slick_dick]

Hey guys, here's my srs dump from Jeep Renegade
Bosch 0 285 013 269

Can somebody help me to clean it up?
Many thanks in advance!


clean and reset

but in what instances

issues with vehicle will need to be repaired programmed etc, you can not clean or reset an airbag ecu!

we are able to unlock the crash data signal sent to ecu only after an impact?

good luck

[tarassych]

all deployed airbags was replaced after accident
and SRS unit flashed with your file

so I'll just wait for few more days to get that cable delivered and try to get airbag codes

anyway, thanks for your help and patience!

[slick_dick]

just remember we can not be held responsible for miss diagnosis!

dont forget the +rep and thanks buttons

respect

[slick_dick]

you are too kind sir!

:applause:

[Abdo Abdelatif]

Jeep Renegade is clear pass ind pm
95640

[tarassych]

hey guys, i'm here again
so I got my cable and was able to connect to SRS computer
there was three errors
2 about deployed airbags, it was cleaned and gone forever
and one which I can't clean

it's B0100 and it says "Error inside the control unit. Internal electronic failure"

is it because of bad soldering or bad flashing I did ?

[Abdo Abdelatif]

other damp pass ind pm

[tarassych]

thanks, will try, but what is the difference ?