Renault Megane SIRIUS32N Automatic transmission IMMO OFF please

[achaccha]

Dear Friends
Please I need your help to do IMMO OFF to this ecu of renault Megane SIRIUS32N Automatic transmission. I have tried some files OFF, the engine starts but does not make the changes and loses communication with the automatic transmission and the scanner.
I wait your help friends
thank you very much

[vanos batam]

Dear Friends
Please I need your help to do IMMO OFF to this ecu of renault Megane SIRIUS32N Automatic transmission. I have tried some files OFF, the engine starts but does not make the changes and loses communication with the automatic transmission and the scanner.
I wait your help friends
thank you very much

try this..............................:tears_of_joy:

[achaccha]

Hello Vanos batan, file not work , any other solution?
thanks



try this..............................:tears_of_joy:

[lupu_sandu]

Hello Vanos batan, file not work , any other solution?
thanks
Try this, cut pin 58.

[achaccha]

Good afternoon.
I have tested your lupu_sandu file but the engine does not start, neither does the scanner enter the engine.
The funny thing is that I tried an OFF file for Sirius32N and then if the engine starts well, but the automatic transmission remains in third gear and the TPS is completely out of control.
If I return the original file that came in this ecu the scanner enters the engine and the automatic transmission. in current data you can see the position of the change perfectly in which you choose PRND and leaving it in D you can see that the change is in First gear. But the engine does not start with this information.
I hope someone can help me please or in any case I hope your suggestions.
thanks for your help




Try this, cut pin 58.

[lupu_sandu]

I checked again my file, is all ok.
Please check you programmer and soldering after.

[Locksmith Hungary]

"ß$¤ßłpúőpúßßłŁ$ßßłjáßßłßł$×÷łŁł¤ß=

[achaccha]

I have tried several OFF files, the engine starts but the automatic transmission is in emergency mode (third gear) plus there are no TPS signals and the CAN communication line is completely dead. when I return the original file I have all the correct signals, only the engine does not start.
I await your comments

[izmir35]

hello there. can u send pass ?