PDA

View Full Version : P307 1.4hdi no start after wiriting with fgtech galleto



rfernandes
28th August, 2018, 04:12 PM
Hi there...
After wiriting a new file via obd the car wont start and the engine light dont show..
After i read via bdm(ktag) and read all ecu..
Any help?
Many thanks..

morgano
28th August, 2018, 04:21 PM
Upload first obd reading and after block bdm reading.

rfernandes
28th August, 2018, 06:25 PM
what do you mean on block bdm mate?

morgano
28th August, 2018, 07:16 PM
I mean bdm read of the blocked ecu after you wrote the tune by obd.

rfernandes
28th August, 2018, 07:34 PM
ahh...ok..
here

morgano
28th August, 2018, 08:10 PM
No mate, is needed BDM read of the ecu in its actual blocked state.

morgano
28th August, 2018, 08:16 PM
No matter, found a backup.

Upload this one to ecu using KTAG or FGTECH in BDM mode. Ecu should be alive again. Pass is same as your last file.

Regards,

rfernandes
28th August, 2018, 08:39 PM
i´ve wrote tha one i sent you mate..it goes to 99% and ingnicion just go off..
tomorow will wrote that one :)
many thanks mate..ill back to you when test

rfernandes
29th August, 2018, 09:58 PM
thanks morgano!!!the car start!!!cheers mate!!