View Full Version : edc17c64 vag gallettov54 not read
garagesport
16th September, 2018, 03:43 PM
Hello colleagues, I am trying to read this ecu edc17c64 vag but my galletto only identifies but at the time of reading it does not read what can happen here attached some photos
sdtsedat
16th September, 2018, 04:39 PM
What error you have if you click read?
Better buy Ktag, works better
garagesport
16th September, 2018, 05:22 PM
it directly exits disconnect current and connect and nothing
mario38
16th September, 2018, 05:44 PM
it seems that the file is protected !! have you tried to eliminate tprot?
garagesport
16th September, 2018, 05:48 PM
yes but neither read
I have ktag but 6.070 and this does not
if I could update to 7.020 without changing the nxp
mario38
16th September, 2018, 05:58 PM
yes but neither read
I have ktag but 6.070 and this does not
if I could update to 7.020 without changing the nxp
do not you use kess v2? have you tried to read in boot mode?
garagesport
16th September, 2018, 06:48 PM
kess v2 just writing
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.