PCR 2.1 EEPROM Bricked?

[vrsho]

Hi,

i have a problem with PCR 2.1. The ecu was unlocked via Galleto Clone. After unlock, the car started normally. But then when i wrote a new map but at 100% i received a error and the car doesn't start anymore. Already tried to put the original map to the ecu but without success. Can it be that the Galleto didn't unlocked the EEPROM in right way?
Later i make a EEPROM backup with KESS and also tried unlocked it - Task was successfully completed, but i cannot put any map into the ecu.
With Kess i can identify the ECU:

SW: 03L906023ML
SW upg.: 03L906023ML 9970


Is the EEPROM bricked or i didn't have a good backup? Thanks a lot.

[Inquizit0r]

Write original EEPROM and original flash with KESS.
If not worked - flash sgo via vag can pro.

[vrsho]

The problem is that i dont have the original eeprom file.

[sdtsedat]

Put ecu in car, connect galletto, Do not ecu data, but open ori file and write. If eeprom not erased, car will start again

[vrsho]

Tried, i receive error at 100% when i write the file with Galleto. EEProm is not erased but is somehow locked i think.

[dominik.m]

Once had similar problem. I tried to repair in different method this.
Without success. I used vag can pro and reflash ecu with sgo file. Car start.

[Team dz]

Program EPROM
Then the flash with the Galleto

Good look

[vrsho]

Thanks, i try it later.

I see by checksum that you unlocked the EEPROM once more? Was the EEPROM not good unlocked?

[vrsho]

Tried but at ending of writing i receive again this error. Any other solutions?

[vrsho]

Once had similar problem. I tried to repair in different method this.
Without success. I used vag can pro and reflash ecu with sgo file. Car start.

Where can I get the sgo file?