carbandit
20th September, 2018, 06:03 PM
hello guys got this 2016 partner done loads of these .....with jc bsi spc560 used smok uhds started to read then as normal put in km i required sw asked me to save bsi flash which i did as normal .... sw then does normal lights on wipers on etc now halfway through proceedure car just goes dead .. nothing working ... reset battery still no response . so then use uhds to reflash saved bsi file gets to 99% then have error write ... any ideas on this sent smok message but as of yet no reply .. car had good battery and jumper pack on it aswell
flash dump is attached
flash dump is attached