Yura123
27th September, 2018, 02:35 PM
On many machines, an error occurs the fault code : 2633 Maf Sensor ; offset drift.
It is eliminated by replacing maf and adapting or for other reasons.
But i need to completely remove limp mode because of this error through the file. Only removing errors does not remove the limp mode.
Does anyone have such a solution?
Thank you very much.
It is eliminated by replacing maf and adapting or for other reasons.
But i need to completely remove limp mode because of this error through the file. Only removing errors does not remove the limp mode.
Does anyone have such a solution?
Thank you very much.