Pinout Renault Bosch airbag sensor

[szkeptmen]

Hi,

I'm looking for a pinout - Renault Bosch airbag sensor, with gray connector.
It has 50 pins.
RENAULT
8200 375 763 /---
BOSCH
0 285 001 537
AB 8.X


Important for me is front airbags (driver and passenger)
( Both two-stage, means 4 wire...)

Someone can help me, please ?

THX + Rep

[Safetybags]

Hi, can I know why you need this pinout???
In autodata you have this pinout...
BR


Enviado do meu iPhone usando o Tapatalk

[szkeptmen]

No...

It's not in autodata...

[Safetybags]

On mine yes....but now I will only in office on Monday....
usually the airbags of this Clio generate defect in one stage, could be on squib 1 or 2, on driver and in passenger to...
You can change airbags, you can put a resistor on wires of the squib defect, or you can unplug them, and then change unit configurations for only one squib airbag...
BR


Enviado do meu iPhone usando o Tapatalk

[julo45]

Bosch AB8.X 50pin gray connector:
pin 6 GND
pin 7 K line
pin23 +12V

[Louislesinge]

Hi,
CLIO 2 and other Renault:
Greetings

[Abdo Abdelatif]

s560102Pinout Renault Bosch airbag sensor: 9s12

[szkeptmen]

Bosch AB8.X 50pin gray connector:
pin 6 GND
pin 7 K line
pin23 +12V

I know this, but I like to know squibs pinouts...
E.g. driver airbag: 2-27 and 3-28
passenger airbag: 11-36 and 12-37

[Louislesinge]

Hi,

I know this, but I like to know squibs pinouts...
E.g. driver airbag: 2-27 and 3-28
passenger airbag: 11-36 and 12-37
Send VIN if you want the full pinout, please.
If you got a fault on passenger airbag (2 units), many times Airbag is out of order. An esasy way to check the beam is to put a short-circuit on terminals, so if state changes from open circuit to short-circuit, it means wires are OK.
Greetings,

[szkeptmen]

This is the airbag ecu... Need a passanger airbag pinout, because the airbag has one connector, the
airbag ecu looking for the second squib (stage)
Yes, original ecu lost, the configuration was: driver airbag with 2 units, passanger airbag with only one unit !

I want to add a simple resistor...

[julo45]

Here you go....