PDA

View Full Version : Volvo v70 not starting



nerijus123
30th September, 2018, 12:34 PM
hi. After i instal new remap with K-tag master to volvo v70 2.4 d5 163hp 2007 Bosch Edc16+ (p68) car not starting at all. I write back orginal file, engine try to start but then nothing.. Maybe somebody have same problem?

smotorsport
30th September, 2018, 12:37 PM
What do you mean engine try to start? Cranks only or cranks+some injection?

nerijus123
30th September, 2018, 12:40 PM
Cranks only for few seconds no injection, then nothing no cranck any more, then if take battery off and on again it carnks again for few seconds and stops.

nerijus123
30th September, 2018, 12:43 PM
maybe somebody can check orginal file?

AVDigitale
30th September, 2018, 12:58 PM
when you opened the ecu maybe you damaged something

nerijus123
30th September, 2018, 01:16 PM
i was very carfull.. but it reads and writes no problem. Can you check orginal file is it full?

nerijus123
30th September, 2018, 01:16 PM
Is it hard to reprogram used ecu for volvo?

pablo1971
30th September, 2018, 01:16 PM
Have you done a DIAGNOSTICS on the ecu..?

Ignasvw
30th September, 2018, 01:17 PM
maybe somebody can check orginal file?
Orginalas tavo failas

smirnoff_rules
30th September, 2018, 01:17 PM
sounds like damage , you can write these without opening anyway just by pinout

Johnner
30th September, 2018, 02:12 PM
Guys, ENGLISH only please !!

nerijus123
30th September, 2018, 02:14 PM
is it hard to reprogram used ecu for volvo?

bodzio012
30th September, 2018, 07:08 PM
EDC16 read and write by ECU plug. Why did you open this ECU?
For reprogram used you need to copy flash and spi,

What tool you used for read and write?

nerijus123
30th September, 2018, 09:18 PM
Im using k-tag or if its possible kess.. i open and use bdm conector.. open because i can not connect with obd conection with volvo ecu

Myjector
1st October, 2018, 07:28 AM
It's not bad at all to BDM these, less risk. But i im almost for sure your damaged an small SMD component that's typical.

Aivis3
1st October, 2018, 09:20 AM
Im using k-tag or if its possible kess.. i open and use bdm conector.. open because i can not connect with obd conection with volvo ecu

For Volvo EDC16C31 need K-Line wire!!! Im using other ECU connector - OBD connector with K-Line wire

porter77
1st October, 2018, 09:58 AM
Fuel maps are ok in Your ori bdm file . Can You post eeprom ?


Cranks only for few seconds no injection, then nothing no cranck any more, then if take battery off and on again it carnks again for few seconds and stops.

nerijus123
1st October, 2018, 03:09 PM
one guy checked ecu he said that 3 transistors and 2 chips a broken.. have no idea how its happens. i found used one. does it fit560565560565

Myjector
1st October, 2018, 03:14 PM
Yes u can you this one