U0427 car don't start after crash citreon nemo 2014 diesel

[ayoub laghrissi]

Hello, anyone have idea how disable this dtc
U0427: défaut de détection de collision véhicule thnaks in advanc
thanks in advance

[teerak2uk]

What module is that dtc in

[ayoub laghrissi]

in ecu moteur
What module is that dtc in

[teerak2uk]

in ecu moteurFault should clear with a good scanner

[voltechcar]

this not work, all fiat have combination which unlock ecu.

[Meat-Head]

this not work, all fiat have combination which unlock ecu.

I agree RTFM something like left turn 3 times, then right 3 Times then left, then engine starts

stabdard fiat

[ayoub laghrissi]

I do but not work

I agree RTFM something like left turn 3 times, then right 3 Times then left, then engine starts

stabdard fiat


this not work, all fiat have combination which unlock ecu.

[Meat-Head]

LEECHED IFF UNFERIOR FORUM

Enhanced Accident Response System




In the event of an impact causing air bag deployment, if the communication network remains intact, and the power remains intact, depending on the nature of the event the ORC will determine whether to have the Enhanced Accident Response System perform the following functions:
Cut off fuel to the engine.
Flash hazard lights as long as the battery has power or until the ignition key is turned off.
Turn on the interior lights, which remain on as long as the battery has power or until the ignition key is removed.
Unlock the doors automatically.


After the event occurs, when the system is active, the message "Fuel Cutoff See Handbook" is displayed.
Carefully check the vehicle for fuel leaks in the engine compartment and on the ground near the engine compartment and fuel tank before resetting the system and starting the engine.
Note:In order to start the engine and move the vehicle to a safe location after an impact, the System Reset Procedure must be completed.




System Reset Procedure


After an impact causing air bag deployment, the left and right turn signal lights, located in the instrument panel cluster, will both be blinking, until the ignition is turned off.
In order to move your vehicle to the side of the road you must follow the system reset procedure.
Customer Actions : Customer Will See
Turn ignition OFF (Turn Signal Switch Must be placed in Neutral State).
Turn ignition ON : Left Turn Light is OFF. Right Turn Light BLINKS.
Turn Right Turn Signal Switch ON : Right Turn Light is ON SOLID. Left Turn Light BLINKS.
Turn Left Turn Signal Switch ON : Left Turn Light is ON SOLID. Right Turn Light BLINKS.
Turn Right Turn Signal Switch ON : Right Turn Light is ON SOLID. Left Turn Light BLINKS.
Turn Left Turn Signal Switch ON : Left Turn Light is ON SOLID. Right Turn Light is ON SOLID.
Turn Left Turn Signal Switch OFF (Turn Signal Switch Must be placed in Neutral State) : Left Turn Light is OFF. Right Turn Light is OFF.
Turn ignition OFF : System is now reset and the engine may be started.
Turn Hazard Flashers OFF (Manually).


If a reset procedure step is not completed within 45 seconds, then the turn signal lights will turn off and the reset procedure must be performed again in order to be successful.