im*o off peugeot 48p2

[youk]

hi , can you edit my file in im*o off, thanks
peugeot 206 s16 iaw 48p2

[ecuwroc]

hi , can you edit my file in im*o off, thanks
peugeot 206 s16 iaw 48p2dump i**o off 29F400 work 100%

[youk]

thanks, i'll test

[eepromRipper]

thanks, i'll test

Hit the thanks button

[Meat-Head]

Hit the thanks button

i was looking for the OPW or OTW button!

[youk]

this file not works on my peugeot 206 s16 2l 16v iaw 48P2.38
help me please !!!

[chacarita]

this is a virgin dump you ca program with pin in any car32359

[youk]

thanks, i will testing

[youk]

i search the file of 206 S16 peugeot sport relais or sprint with immo off

[youk]

i have the file 64ko and i search the file 512ko

[youk]

up :bounce:

[motor6605]

Hello.
Test this immo reset.

[youk]

hi
don't works
the ecu don't boot

[motor6605]

It's 206 phase 2. Test configuration pin and appairage BSI /ecu with pp2000.

[Meat-Head]

up :bounce:

down



hi
don't works
the ecu don't boot

It's french it's cure one fault, gain another OR it will have at least
2 faults anyway

[youk]

with your file the ecu is out of service
with other files ecu ok but the motor don't boot

[chacarita]

Tell us ecu number , is bosch?, Mangeti Marelli?

[Furax]

That code is for a magnetti 3 plug ecu.

Immo killer doesnt clear the immo it just overwrites it with a map off a 1.1 thats got immo off, this ecu ran various engines.. same thing different map.

[youk]

my ecu file for 206 s16 2.0 16v iaw 48p2.38
my code pin 1GJ9

[dgmcan]

Hi!

Try this one..

[youk]

don't work

[chacarita]

don't work
Dont you test previus dump i post?, is virgin for 2.0, is not inmo of but if you have code you can program it

[chacarita]

is it phase1 or 2?

[youk]

this is a ph1

[idalgo63]

Hello, I've just registered. I came across this site while googling IAW-48P2.38 and I see some helpful guys are posting ther ECU dumps here.

My 206 GTI 16v 2.0 from 2001 has an intermittent starting problem that my pug dealer traced to the cable harness (expensive replacement!). Sometimes it fais to start though it cranks. With PP2000 I read the ECU errors and there was someting related to not receiving the key code because of some ECU input shorted. Pulling out the ECU and wobbling the connector cables usually helps the problem and the car starts normally.

I thought that instead of a costly replacement of the harness I'd rather bypass the immobilizer, then it wouldn't matter whether the input is shorted or not.

I have no ability to access my ECU***347; memory contents, so before overwriting my ECU with PP2000 I wonder if all ECUs with ref. nr. IAW48P2.38 carry a software able to run my engine, then I could use the file posted by youk as a back-up in case anything goes wrong with reprogramming.