Charlton
12th October, 2018, 11:18 AM
Hello Everyone
I hope you guys are all well today...
Guys I've been having some issues with key coding on a opel corsa D Z14exp
If I may just give u a brief bit of history on this Opel.
Car was towed in for a blown cylinder head gasket. The cylinder was already remover when I came in. I did all the work and put everything back .I turned on the ignition ,ready to start and saw the spanner with the car light flashing on the instrument panel.
I connected ABRITES ,selected Opel and tried to read the security code from the ecu but it says ' NO security code programmed'.
When I read the info display module it gives me a code 7624.
Instrument cluster target does not respond.
I ran a diagnostic on the ecu using ABRITES and found 3 faults
Ecu faults.
P2501 generator lamp
P1679 wrong transponder key
P1679 wrong environment identifier received for BCM
I'm not sure what fault code P1679 really means. I got another BCM but same fault code
I've tried using OPCOM and still no luck.
I wanted to find out if someone can maybe check the system that I have and maybe program a pin to the ecu and maybe line the system up for me if needs be.
Or if someone has a system that could maybe work for me ?
I've attached the ecu flash ,info display 93c56 and the instrument cluster 080 chip
I'm not too sure how to get the info off the BCM
Any help would be appreciated
Thanking you in advance
Regards
I hope you guys are all well today...
Guys I've been having some issues with key coding on a opel corsa D Z14exp
If I may just give u a brief bit of history on this Opel.
Car was towed in for a blown cylinder head gasket. The cylinder was already remover when I came in. I did all the work and put everything back .I turned on the ignition ,ready to start and saw the spanner with the car light flashing on the instrument panel.
I connected ABRITES ,selected Opel and tried to read the security code from the ecu but it says ' NO security code programmed'.
When I read the info display module it gives me a code 7624.
Instrument cluster target does not respond.
I ran a diagnostic on the ecu using ABRITES and found 3 faults
Ecu faults.
P2501 generator lamp
P1679 wrong transponder key
P1679 wrong environment identifier received for BCM
I'm not sure what fault code P1679 really means. I got another BCM but same fault code
I've tried using OPCOM and still no luck.
I wanted to find out if someone can maybe check the system that I have and maybe program a pin to the ecu and maybe line the system up for me if needs be.
Or if someone has a system that could maybe work for me ?
I've attached the ecu flash ,info display 93c56 and the instrument cluster 080 chip
I'm not too sure how to get the info off the BCM
Any help would be appreciated
Thanking you in advance
Regards