Xprog-box CAS3 CAS3+

[omglol]

Hi!

Where can I find connection diagrams for CAS3 and CAS3+ for Xprog-box? I cannot seem to find them inside software.

Are these safe to do with Xprog-box? I have original software from eldb. Thanks!

[karalada]

Here you go

[omglol]

Hi!

Thank you very much. Where can I find similar diagram for CAS3+?

[omglol]

Looking at the picture again, is that CAS3+ displayed, while CAS3 is missing?

[tomvleeuwen]

I think the CAS3 hardware is identical (or at least very close to) the CAS3+.

[brend]

For this no need cas picture in x-prog program inside.
Just open by mcu type conection check/find this lokation in cas mcu ,use for this same tester ,thats all.
For this job you must more anderstand if you want future work with this.............;)
You have all information for this,just use this right ,thats all.
Simpel!

About yours cas3+!
Inside secured mcu!


Hi!

Where can I find connection diagrams for CAS3 and CAS3+ for Xprog-box? I cannot seem to find them inside software.

Are these safe to do with Xprog-box? I have original software from eldb. Thanks!

[omglol]

Yeah, already successfully done. I only asked to avoid risk. I asked for a picture insider the software because I remember there were pictures of BMW CAS units, but now somehow they are missing. Also, you need to follow specific instructions, which are different between programmers even for same CAS units.