View Full Version : Reading and programming mcu 68hc05k3
cartech
1st December, 2009, 09:02 AM
hello all!
I need help to read this mcu 68hc05k3.
is there any programmer schematic to read/program this circuit?
or
which good programmer to do that.
I need help on that please.
thanks.
NB:I have UPA usb and etl but can't do that.
isak2009
2nd December, 2009, 08:35 AM
Use Xpog m do it
I test it in isp
cartech
2nd December, 2009, 10:01 AM
it have this reference of mcu on xprog-m??????????
isak2009
2nd December, 2009, 12:58 PM
yes , for ir infra red key megange
harryauto
3rd December, 2009, 06:06 PM
yes , the best of X-prog-M
but u can use the ETL programmer , u need change ETL crystal , 4M change to 20M will be ok.....
cartech
5th December, 2009, 03:34 PM
really!
how with etl?
must select which reference of mcu?
thanks
cartech
6th December, 2009, 08:35 AM
thanks for reply!
can u explain me more please
crowbareight
6th December, 2009, 05:04 PM
Hey chaps look here
www.telwis.pl (http://www.telwis.pl)
it might interest you
another_seller
13th March, 2010, 06:28 AM
hello all!
I need help to read this mcu 68hc05k3.
is there any programmer schematic to read/program this circuit?
or
which good programmer to do that.
I need help on that please.
thanks.
NB:I have UPA usb and etl but can't do that.
hi m8, xprog-m can work with it
cartech
13th March, 2010, 08:12 AM
hi m8!
I have just upa-usb and etl programmers, possible to do it??????????
thank u
cartech
16th March, 2010, 08:10 AM
no help about this!!!!!!!!!!!!
impossible with upa or etl???????????
thank u
cartech
20th July, 2010, 06:42 AM
hi:
I success to read the dump from mcu IR remote key.
now how to program new one
AndrBorts
9th February, 2011, 10:55 AM
I have this problem too
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.