VW Sharan 2002 immo problem

[aaruncee]

Hello,

Problem: Custumer did mistake and put wrong immo ecu in the car (from another VW Sharan) and now car don't start. I had read pin code, but can't do key adaption because in[IMMO -25] - [Adaption- 10] - 01 channel Get ERROR.
I tried do ECU Swapping in 50 channel but nothing changes.

How to fix this problem?

Wv Sharan 2002

IMMO ECU:
7M3 953 257
IMMO 0008
memory: 24c04
IMMO ID: VWZ1Z0BXXXXXXX
Pin code: XXXX8

[ana_11]

read pin on new ecu and odometer(immo)

go in instrument cluster
log in old pin
go to adaptation channel 50
and enter pin on ecu and ok.
and work

[yasser]

it is diesel or petrol?

I think real problem was not changing ecu's or im*o box.
If it diesel there is chance to start car whithout searching im*o box correct signal.

[syncro]

Which parts are original. key, ecu, im*o, two of the three must be from the original car. If only the im*o is wrong then goto adaptions 50 put in the pin from the im*o to release it. then enter the pin from the ecu to the im*o to match it to the car. check the vin from the ecu and im*o now match. key programming should now be possible.

[jokersat]

im*o off

@+

[Ashraf6119]

Hi

If your old ECU unit is with you and its fine you can replace it back and just disconnect the battery for few min than reconnect it back it should reset back to its normarl settings.

Or if you rearlly do need to replace the ECU unit then have a look in this links.

Ross-Tech: VAG-COM: im*obilizer 3 ECU Swapping (http://www.ross-tech.com/vag-com/cars/im*o3-ecu-swapping.html)

Or this one select which every system is your car im*o 1 or im*o 2 or im*o 3

Ross-Tech: VAG-COM: im*obilizer Info (http://www.ross-tech.com/vag-com/cars/im*obilizer.html)

Hope this helps

Ash