PDA

View Full Version : Please help!


orestas1500
25th October, 2018, 03:11 PM
I swaped opel astra-g ECU and then on imobilisier I did reset ecu and after on programming option I pressed Engine ECU installed after that I go to measurment and where the Transponder Status it says Wrong TP-Key.
I tried to program new Immo chip but the same happens. Maybe I forgoted something. Please help !!
rafal
25th October, 2018, 04:37 PM
..................................
orestas1500
25th October, 2018, 04:53 PM
I was reading this. I tried to reset the ecu then do everything from 0 again. Still it says on transponder status wrong tp-key. Image will show what i mean567012
rafal
25th October, 2018, 04:55 PM
I was reading this. I tried to reset the ecu then do everything from 0 again. Still it says on transponder status wrong tp-key. Image will show what i mean567012
read again all info what i sent
orestas1500
25th October, 2018, 05:04 PM
Well I were reading it from yesterday. I tried new chip, but the same. Please... Any ideas? Push me to right way, maybe I did something wrong, or not in sequence. Yesterday engine was starting for 3 seconds and then stalls. I think it was that 10 times until it locks itself. If I understand correctly when I reset ecu with carprog it should start again for few seconds or am I wrong ? I have another one Immobilisier which is under steering wheel. Maybe it's immobilisier fault? But If I swap those I need to know the PIN of it. The only way to do it is to read tms am I right? Or am wrong and...All I want is to fix it and thats all. Please someone... Only me having this problem??
rafal
25th October, 2018, 05:09 PM
post ecu info first
- carprog clone not doing well reset
orestas1500
25th October, 2018, 05:21 PM
https://ufile.io/ek3gf info and dump https://megaupload.nz/65I3K2j0b4/Desktop_rar
rafal
25th October, 2018, 05:38 PM
http://www.digital-kaos.co.uk/forums/showthread.php/315999-Astra-G-Y17DT-ECU-problem
orestas1500
25th October, 2018, 05:49 PM
Thanks rafal for help, but this info is not usefull for me.....
orestas1500
25th October, 2018, 05:53 PM
What I'm trying to say, if transponder status went to correct-tp the engine should start...
orestas1500
26th October, 2018, 06:31 PM
Well thanks for "GOOD" advices, but I fixed it by myself. The proplem was TMS. I bued used immo box, soldered out TMS and readed the PIN then I reset ecu with carprog and after on opcom i programmed immo function "ecu installed (replaced)" and finnaly I've put new immo id40 chip and programmed succesfully. Maybe it will help to somenone

Išsiųsta naudojantis F5121 Tapatalk 4 Lt