VW Transporter T4 Immo problem

[lupu_sandu]

Hy guys,
I have a really annoying problem here.
One friend with VW T4 '98, 2.4l engine, have lost keys
I read Immobox - is a TMS
But all problems starts here:
- i can't make keys using Gambit (it give me an error - i try PCF7935as, T5, ID42 VAG Crypto),
- i can't make key using VCDS
Immo off in immo is possible like Immo1 with HC05?
Or some solution for this car?

[MOBILTRONIC]

How we think it is a VW immobox 2 Siemens, TMS 370C702 and chip is PCF 7935, SILCA T15, JMA TP14.Try with those of Gambit and diagnostic.What is login? Had to be able to login with read code and chip in which are stored in the content of any FF, programmable key.I try read login with your dump.Goog luck.

[titona]

If it is the immo system i think it is, then you can just break the little box on the diesel pump and connect both wires to the "magnet valve".

A small hint from a VW mechanic.

[odyseus7]

hi.i had the same problem before a week.you must read the 24c02 in ecu and upload to forum.work 100%

[lupu_sandu]

I don't think that this car have ECU.
Is a 2.4l engine, vcds will not connect to ECU.

[MOBILTRONIC]

Friend, it is probably 2.4 or 2.4 Diesel TD and he goes to the module DIESEL PUMPS not the ENGINE.You can not run diagnostics on the module, but the engine would certainly must go to the module imobillizer if is ok.If the diesel engine, and it seems, then removed from the pump part that communicates with immo, slowly, come to electrovalve of fuel and connect it to + Kl.15 try turn, will starting little longer but it should turn on if the heaters are all correct, relay office and has to fuel pumps.

[syncro]

When I tried car key programmer II on vw TMS im*o it wrote id33 key from a pcf7930 which is wrong. I have sucessfully replaced them on a couple of ocasions with a hc05 im*0 when they have refused to program keys(both been ecu's though)

[lupu_sandu]

Syncro how do you change Immo TMS with immo with hc05?
Have different pinnout.

[syncro]

I use the hc05 Im*o reader coil and splice in the wiring from the other plug to the tms harness. hco5 only has ignition live,earth,k-line and w-line. If need be I can check the pin designations at work tommorrow.

[lupu_sandu]

Please, if you can, post here.

[syncro]

here is the pinouts let me know how you get on.

7740

[martinbr]

mobiltronic it's write there is no ecu so it's easier to conect the pomp valve and you don't need syncho or key
regards

[jimthejock]

the vehicle needs this type of chip to write the key data on to Philips PCF7935 - Silca T15 - JMA TP14 as it is active when it is loaded into the correct software it goes automatically to this to write the key on tm pro

[nazz2]

or a precoded 42,for z bull cloner.

[kolobok1967]

key programing

[MSolen]

here is the pinouts let me know how you get on.

7740


I had the case from Polo 99 immobox on TMS and with your way went without the problem. The immobox change to HC 05 and the car is working without immo. Here it walked, great thanks!!!