Reneprog error

[Rtronics]

Hi, looking for someone with reneprog experience.

i have desoldered new Subaru BRZ 1725 mcu ad put on adapter. when i connect with reneprog 1725 it gives me wrong password. when i connect with 1725s i get jtag error.

i gave checked soldering and mutimetered every single point. resoldered 20 times.

heres something funny. connect reneprog with serial programmer it reads id etc. try to read id or flash error.

what the hell.

i have read flash at least 10 before, iont know what is going on with this one.

see pictures.

[slick_dick]

iv had this issue!!!

cant remember what i did though :(

if i remember correctly i may loaded the flash in reneprog then opened serial and pressed write

ensure mcu is ultra clean even a spec of dust may cause issues, use magnifying glass to look at each leg.

good luck

slick

[Rtronics]

it didnt work for me. ifou could remember it would help. no else hve received this error?

[slick_dick]

are you using new ziff socket or soldering to board?

i burnt my board out and bought the ziff socket.

have you emailed canalyser at autokey

im sure the mcu needs more cleaning, use microscope to check each tiny leg

[sbkracer1]

slick is right, its simply a connection problem.

[alexs600]

I had same problem- with "pass being wrong" massage

98221SG160
could not read on adapter ,after spending long time checking -finaly gave up :banghead::banghead:
"tried program different flash-it programmed ok ,and was able to read flash that I programmed

Some time later had same part# but diff module -"READ AND WRITE AT FIRST TRY"-unit working ok
what number you have?

[miffy]

I also can't connect the device. Reneprog has been installed successfully, and the SRS board is wired. I can't connect the device while reading the ID. Does anyone help me?ˇ

[automotrizVIP]

This usually happens when the USB port of the laptop or PC, does not generate the voltage. that is why it is recommended to use external 12v in the module or a USB backup cable as the following




https://ae01.alicdn.com/kf/HTB1HoGdXNHBK1JjSZFkq6zg9VXaU/USB-2-0-A-macho-A-B-macho-AM-BM-con-Cable-de-alimentaci-n-Y.jpg_640x640.jpg

[miffy]

617265xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

[automotrizVIP]

617265我注意到USB + 5V，但當Reneprog讀取ID時，指示燈閃爍1秒，並且沒有安培電流通過。屏幕顯示無法讀取設備。有 人能幫我嗎？我該怎麼解決？


read the rules.
The forum you write in English

[miffy]

I noticed USB+5V, but when Reneprog reads the ID, the light flashes for 1 second, and there is no ampere current passing. The screen shows that the device cannot be read. Can someone help me? How should I solve it?

[miffy]

I have tried the USB backup cable, but I still can't connect the device. Just connect the mcu board. The power light will stop and then the device cannot be connected. How should I solve it?

[miffy]

Turn on the device, connect GND and +5V together and connect the plate at the same time, the power will stop. Can not read the device, please help me Thank you