Iveco Daily Speed Limit remove

[BeianM]

Hi, can anyone remove the speed limit of this file. This vehicle is fitted with a tacho.
Many thanks in advance :)

[waldi1979]

You can write this file - w/o limiter.

[BeianM]

Hi, many thanks.
This is actually fitted in an Optare Alero minibus. Based on Iveco drivetrain. There are many owners in my group who have converted the bus to motorhome & need this limiter off.
Lots of different code in this file I assume it is a virgin file? I read on DK that unlimited file in ecu does not work when vehicle fitted with a Tacho.
Also, will this file allow Cruise Control?
I have been looking for Iveco software to do this but can't find a working download link.
I will try & let you know.
Cheers
Brian

[Meat-Head]

Not sure but go pester lupusandu

[waldi1979]

I tested this solution few times and it always was working but I don't know if CC will work (my cars didn't have it).

[BeianM]

Yes working here too. Just come back from test drive. Can I flash this to other vehicles, looks like a virgin file. I'll fit a CC stalk & report back.
Thanks again for this.

[Meat-Head]

What did you read and write this with please

[waldi1979]

Can I flash this to other vehicles

Yes, if you have 814.043S engine.


looks like a virgin file.

Immo data are stored in 24C16.

[BeianM]

Thanks again, could not see this ecu in nyo. Is this also map data, Bus seems more powerful, but could be my imagination. Could do with re-mapping.
Have found this https://www.digital-kaos.co.uk/forums/showthread.php/249340-Iveco-Daily-2-8-tunning?highlight=iveco+daily+tuned+map
Looks to work with Cruise Control

[BeianM]

What did you read and write this with please
OBD1260 & EOBD2 soft (serial 1260) done in seconds.

[DrLoopyTunes]

Hi Brian - I also have an Optare Alero and I am trying to remove the limiter, but I can only find an Iveco connector (round one with loads of pins)
How did you connect your OBD-II? Once I get connected, I assume I just download the old one (in case the new one doesnt work) and upload the new one?
Thanks!

[immokill]

U can do it by wire https://uploads.tapatalk-cdn.com/20190117/ae2a9fb5d58d746352f9f34a24283c0e.jpg

I read like rhat conect obd with wires to iveco cobector and it works.

[DrLoopyTunes]

That's fantastic - thanks for your help!! Just need to check I have the right engine series before I screw it all up...! :palm:

[BeianM]

Hi sorry I only just come back to this thread, how did you get on? Most adapters are wired incorrectly. I piggy-backed a obd socket onto the k-line & power.
I see you are in Poole, so am I :)