View Full Version : Strange situation edc17c60
sdtsedat
8th January, 2019, 03:17 PM
Hi people,
Today i tune citroen Jumpy 1.6ehdi with edc17c60 ecu.
I take out ecu, pul the plugs, underside from ecu have contact with + plus on battery and there was flash (little bit fire)
Now car no more start, i pull out battery for 10min again no start. I plug out ecu and plug in and car start?
I open ecu try to read, without succes.
Now no more start.
Someone idea?
Verstuurd vanaf mijn SM-G960F met Tapatalk
Forever13
8th January, 2019, 03:18 PM
Neeed correct checksum
Contact me i repair it
Envoyé de mon SM-G925V en utilisant Tapatalk
sdtsedat
8th January, 2019, 03:28 PM
I dont read write, how can checksum wrong?
All lights are on: eml, esp, abs, tire pressure.
There is no contact with ecu.
Do you think the ecu damaged?
Verstuurd vanaf mijn SM-G960F met Tapatalk
Ignasvw
8th January, 2019, 03:30 PM
Ground wiring in ecu must be burned. open ecu and inspect
sdtsedat
8th January, 2019, 03:32 PM
I think also, but why started car again after pull out battery for 10min? What i do is only opened and try to read.. without succes
Verstuurd vanaf mijn SM-G960F met Tapatalk
raceshadow
8th January, 2019, 03:46 PM
Open the ECU and check the PCB. Something will be burned. FET, diode pcb way.
Pyromaniak
8th January, 2019, 06:37 PM
if ecu was in car with cover and you short cover to plus on batery-- i think ground in ecu too, or pins to pcb, or ground wires check. if car start, i thing its no big problem
when this ecu open you must be a careful to pcb..... this ecu can kill bending pcb by uncovering
gege974
9th January, 2019, 01:13 AM
Hi
if your ecu does not communicate anymore, it is replaced.
check anyway if you have skipped a component on the pcb by opening it.
bersch8688
9th January, 2019, 06:10 AM
Read DTC after remove 10min Battery from Car
sdtsedat
9th January, 2019, 07:58 AM
Update:
Ecu opened, no ground connection. I put cable from ground to ground, and reading full OK!
Second question, is these ecu clonable with Ktag v7.020?
Pyromaniak
10th January, 2019, 10:47 AM
Update:
Ecu opened, no ground connection. I put cable from ground to ground, and reading full OK!
Second question, is these ecu clonable with Ktag v7.020?
try it :) i´m also interested
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.