Volskwagen Amarok 2014

[Dr. Zoidberg]

585723after correcting km with original carporg, the board was showing error, and now there is no communication by obd2, is there any way to repair the dump? or right to be corrupt information, this has no solution?





585714585716

[Maartinj]

585723after correcting km with original carporg, the board was showing error, and now there is no communication by obd2, is there any way to repair the dump? or right to be corrupt information, this has no solution?





585714585716
repair as always ...restore to genuine epp

[Dr. Zoidberg]

eeprom ori is the same, read by obd2, I recognize that it was my mistake not to read in the bank

[Maartinj]

eeprom ori is the same, read by obd2, I recognize that it was my mistake not to read in the bank
mistake cost you $$ as always

[mikkhh]

send better pic of error. Red lcd cluster in 2014? in my area never seen amarok with red clocks

[Dr. Zoidberg]

checking the file, apparently my carprog corrupted my vin number.

[mikkhh]

this car starts without cluster or immo data in cluster?

[Dr. Zoidberg]

this car starts without cluster or immo data in cluster?

Inmo in the clusters, but truck turn on without problem, only appear error



585790

[maumaumau]

post the cluster part number,maybe someone will have a good dump...and comparing a good dump with your corrupted one,you might realize which area is corrupted...hard to believe,but one time i fixed like this (copy different areas from good to corrupted) a 2004 audi A4 with RB crypto 24c08,have to mention the immo data wasn’t corrupted,car start normal (like in your case),only gauges weren’t working

[marina_rv]

write change new km soft X-Tool and the error should disappear.

connect diagnostic tool and show errors.

[Dr. Zoidberg]

write change new km soft X-Tool and the error should disappear.

connect diagnostic tool and show errors.
xtool dont works, dont appear VIN.

[gandrade]

Hello, I have an original 24C64 eeprom from an amarok 2013, I hope it helps you. so you can repair your board.
This eeprom is original of the truck, before programming the second key.

here (https://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=585968&d=1547140078)


If this was helpful Thanks + Rep



585723after correcting km with original carporg, the board was showing error, and now there is no communication by obd2, is there any way to repair the dump? or right to be corrupt information, this has no solution?





585714585716

[Dr. Zoidberg]

thank you very much for your help, but I understand that these scripts are crypted, you can not put the data of another truck, thanks again .

[qeso705]

Read ImmoData, write e2 from same sw version, write ImmoData and Mileage and everything should work. Be carefull to not lost ABS and Engine coding.