Immo off Golf 4 Edc15P+

[Kalectro]

Hi all.
I need immo off to the Ecu
EDC15P+ 0 281 010 974
Here is the 24c04 dump.

Best regards

[oliva]

immo off edc15p

[Kalectro]

Thanks, but the file does not start the car

[icezero2010]

Hi all.
I need immo off to the Ecu
EDC15P+ 0 281 010 974
Here is the 24c04 dump.

Best regards




in your file is immo off problem is on car

[KIMICE93]

if you have a problem with the immo on your car : you car must start and stop after 1 OR 2 seconds later

[Kalectro]

Ok thanks, I have these dtc in the dashboard:

[Kalectro]

...and this in the engine ecu :

[Cyrez]

Hello my friend,
i found this at ross-tech (VCDS) Q&A:

Possible Causes

Immobilizer

Wiring and/or Connector(s) from/to Immobilizer Reader Coil faulty
Immobilizer Reader Coil faulty
Immobilizer Transponder in Key faulty OR incorrect Transponder in Key


Remote Control

Remote Control Battery low
Remote Control faulty OR incorrect Remote Control used


Possible Solutions



Immobilizer

Check Wiring and/or Connector(s) from/to Immobilizer Reader Coil
Check Key Immobilizer Transponder Status

See Measuring Value Blocks (MVB)


Check/Renew Immobilizer Key Matching (http://wiki.ross-tech.com/wiki/index.php/Diagnostic_Procedures#Immobilizer_Information)
Check/Replace Key


Remote Control

Check/Replace Remote Control Battery
Check/Replace Remote Control



@First i think it would be easy to check Keybattery or coil of ignition lock with a multimeter.

[Kalectro]

Thanks
There is no battery on this key.
and the engine is just crancking.

[AndrewStone]

Hi all.
I need immo off to the Ecu
EDC15P+ 0 281 010 974
Here is the 24c04 dump.

Best regards




Immo is off already in this file

[Kalectro]

Immo is off already in this file
So the car should normally start. But this is not the case.

[AndrewStone]

So the car should normally start. But this is not the case.

what is the problem, tell me!

[AndrewStone]

...and this in the engine ecu :

01177 - Engine Control Unit01177 - Engine Control Unit: FaultyPossible Symptoms

Malfunction Indicator Light (MIL) ON

Possible Causes

Wiring and/or Connector(s) from/to Engine Control Module (ECM) faulty
Engine Control Module (ECM) incompatible
Engine Control Module (ECM) faulty
Engine Control Module (ECM) modified

Immobilizer removed
Chiptuning (Chip replaced)


Possible Solutions

Check Wiring and/or Connector(s) from/to Engine Control Module (ECM)
Check/Replace Engine Control Module (ECM)
Check Engine Control Module (ECM) for Modifications

Old Style Chip Tuning where actual Chips are replaced may have resulted in bad Soldering or otherwise broken the ECM.



01177 - Engine Control Unit: UnauthorizedPossible Symptoms

Malfunction Indicator Light (MIL) ON
Engine Start not permitted

Possible Causes

Immobilizer not adapted
Engine Control Module (ECM) modified

Immobilizer removed


Possible Solutions

Check/Adapt Immobilizer


01177 - Engine Control Unit: Not Currently TestableSpecial Notes

When Found in Instrument Cluster (J285), check Engine Control Module (ECM/#01) for Fault Codes. This Code may be stored when the Cluster is unable to properly determine the Status of the ECM due to Communication Issues or because the ECM is occupied by other Tasks.

[AndrewStone]

can you post me flash from ecu?

[Kalectro]

Ok no problem

[Kalectro]

The Flash dump:

[AndrewStone]

The Flash dump:

and car info

[AndrewStone]

and full ecu data from label

[karimdz]

Hi m8,

her is your dumps with immo off if you need , but you must chek your injection system,

HW: 0281 010 974
SW: 1037 36 6203

[Kalectro]

Ok
We have this on the ecu
038 906 079 AT
0 281 010 974
Edc15P+

[AndrewStone]

Ok
We have this on the ecu
038 906 079 AT
0 281 010 974
Edc15P+

your flash is different from my, check this

[Kalectro]

Yes, I saw some difference
But, apparently, the dump is not corrupt.

[AndrewStone]

Yes, I saw some difference
But, apparently, the dump is not corrupt.

upload and check, how car run, of course if you use boot mode, our via progammer

[kiszka]

gentlemen
You think that castration will help the strength of the flash
if only eeproms are enough in this ecu
as I read
What are they doing here?
I do not know whether to cry or laugh

https://www.digital-kaos.co.uk/forums/images/styles/DarkCore/attach/rar.gif 29f400bt 0281010974.rar (https://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=586936&d=1547473781) (154.7 KB, 1 views) is 038906019AT SG1575
https://www.digital-kaos.co.uk/forums/images/styles/DarkCore/attach/rar.gif VW Golf 4 100 HP 1037363166 0281010974.rar (https://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=586962&d=1547478874) (154.6 KB, 2 views) is 038906019AT SG1513
such a slight difference


your flash is different from my, check this

[karimdz]

1-chek power + in pin 1 and 2 of ECU , power in pin 37 is ok because you can do diagnostic without problem

[Kalectro]

I have 12v on the pin 1 and 2

[Kalectro]

Help me please

[larbou83]

Hi
the immokiller software does this ecu in 24c04

[kiszka]

Hi
the immokiller software does this ecu in 24c04
:lol: :lol: :lol: :goodpost: