kaczor2502
1st February, 2019, 08:36 PM
Hello,
when I try to make a card in megane III, the following log pops up in ecu tool. The car is from 2016 (ecu tool does the car by 2015, but I made a few of them from 2016), from the log it looks like there was a computer like in clio IV at least after trying to connect with the car.
[17:49:27] Status : Reading UCH Identification...DONE
[17:49:27] Status : Reading ISK:
[17:49:40] Status : STEP_1...FAILED
[17:49:40] Status : Oops, something went wrong :(
[17:49:40] Status : No need to worry if car "hung-up", just disconnect battery for 1 minute :)
[17:49:40] Error : comm lib1 framework function CAN_RX_FRAME could not receive CAN frame
[17:49:40] Status : Waiting For Commands
when I try to make a card in megane III, the following log pops up in ecu tool. The car is from 2016 (ecu tool does the car by 2015, but I made a few of them from 2016), from the log it looks like there was a computer like in clio IV at least after trying to connect with the car.
[17:49:27] Status : Reading UCH Identification...DONE
[17:49:27] Status : Reading ISK:
[17:49:40] Status : STEP_1...FAILED
[17:49:40] Status : Oops, something went wrong :(
[17:49:40] Status : No need to worry if car "hung-up", just disconnect battery for 1 minute :)
[17:49:40] Error : comm lib1 framework function CAN_RX_FRAME could not receive CAN frame
[17:49:40] Status : Waiting For Commands