Renault Clio 1.6 16V 2001 - SIRIUS 34

[CARPARTS]

Renault Clio 1.6 16V 2001 - SIRIUS 34 WITH CAN

ECU = SIEMENS SIRIUS 34 // S118301109-A // 8200164131

immo off :

is this possible with flash, or need to install emulator ??

C*L*-immo have a solution with emulator, but the manual is horrible to understand the details...


If someone have experience with emulator, i have 3 questions :


1) i MUST cut & connect can-lines in the UCH-module connector, or is this NOT necessary, to start the engine ?
or is this just an option to prevent "easy theft" ?

2) is it necessary to cut 88 from connector, or not ?

3) C*L*-immo talk about "in order to start you need to join 2 pins from starter relay"
......which relay in my picture is the starter relay ? 1, 2, 3, 4 or 5 ?


Thanks for advices

[vladanr]

if your key and uch are ok you can make in flash autocoding and thats it,if not you have to put emulator ,you have pictures in julia emulators site.if red led blinking faster when you give ignition that is key problem if light all time then is engine ecu

[CARPARTS]

if your key and uch are ok you can make in flash autocoding and thats it,if not you have to put emulator ,you have pictures in julia emulators site.if red led blinking faster when you give ignition that is key problem if light all time then is engine ecu

ok, here is the original flash

...as i say, i do NOT understand the description in the julia-pdf


autocoding : is this only programming the flash with a new file and connect ecu to car, or i need diagnose to marry the ecu ? what's the correct procedure ?

[vladanr]

594515here you are write flash,you dont need to coding only start car