ECU MAGNETI MARELLI IAW 1AP.80 CLONE

[boumbergeg]

HELLO PLEASE I WANT TO SWAP MY OLD ECU MAGNETI MARELLI IAW 1AP.80 (DAMAGE) BY NEW ONE SAME I HAVE KTAG V2.23 AND KESS V2.47 CAN I clone the new one and what is the steps should i folow thanks

[Panathaole]

i think you can make immo off that ecu... not clone....

[Zmann]

If you're skillful then swap TMS374 otherwise check that the bad ECU can still be read with Xprog but not with KTAG AND KESS !

[haingoben]

use clock file erase for immo off,take other 28F512 memory and program this file ,cut 27/48 ECU PIN ,solder the new chip and plug one car 1MIN ,solder original chip.immo off is done

[boumbergeg]

thank you but please more details im new :itsme:

[boumbergeg]

use clock file erase for immo off,take other 28F512 memory and program this file ,cut 27/48 ECU PIN ,solder the new chip and plug one car 1MIN ,solder original chip.immo off is done
mr haingoben thank you but i don understand i remove 28f512 from mother bord and write your ecraser file with xprog afer cut 27/48 pin of ecu tms374 after solder 28f512 memory put in the car 1minute after remove the ecu and solder 27/48 pin and its done !!!
now i dont have xprog can i do this by carprog ,??

[boumbergeg]

I FOUND SOME MANUAL IN THE WEB BUT I CAN NOT UNDERSTAND PLEASE CAN YOU CLEAR THIS IMAGE THANKS
594847

[rafal]

xprog and carprog not support 28f512

you can use :
http://www.ezoflash.com/

[boumbergeg]

xprog and carprog not support 28f512
so rafal please witch tools i should use to flash this 28f512 memory and this ecu !!??

[rafal]

so rafal please witch tools i should use to flash this 28f512 memory and this ecu !!??

i edited for u my post #8

[boumbergeg]

xprog and carprog not support 28f512

you can use :
http://www.ezoflash.com/
i found only software but i where i buy the programmer hardware and adapters

[mikroel]

MiniPRO PROGRAMMER , cheap and work well


Sent from my iPhone using Tapatalk