Piaggio Porter EDC17C08 problem

[centrohifi]

Hi ..
have problem on this unit, I have already worked other times with Swiftec, always ok, but with this ECU, swiftec does not work well.
Disconnect sensors as indicated, but auto recovery immediately, no DTC error!
if connect, pressure sensor, car out of recovery, but exceeded 60Km / h enter recovery, Mil OFF, zero dtc in ECU!

"Swiftec " no work
" dpferase " no work


You can work file with "Winols" to test ?

Bosch 0281020177

dtc active P244B



Thank you

[Ignasvw]

upload swiftec solution

[centrohifi]

....these are the files ...

[Ignasvw]

Write this

[centrohifi]

Thanks .. but does not work, dtc off, but exceeded 3000 rpm, goes into recovery.
With disconnected sensors start in recovery, no DTC!


I have done other tests, or uploaded files ori, the dtc P06BA (cylinder 2 candle) is always present. All the "mod DPF" files loaded, the DTC disappears .......


Then the DTC P244B (differential pressure above limit) appears active after 3000 rpm, OFF-ON engine error not active and car not recovery.

" I burn it "

[centrohifi]

this is new reading, with pressure sensor disconnected
DTC P244B
P2455

[GianniNOS]

try with this, on my car work well

[centrohifi]

@GianniNOS la PW ... Grazie

[pike]

this is new reading, with pressure sensor disconnected
DTC P244B
P2455

Hi, limp mode with this DTCs?

[centrohifi]

yes "limp mode " 2800-3000 rpm ... always
connect sensore start engenie " no recovery " exceeded 3000 rpm enters recovery, light on !!! OFF-ON enginie go out recovery !!!!

excuse my English :(