webonline
10th September, 2008, 09:48 AM
I am trying to update my new EV5000 PVR with the latest UFL firmware 1.1 / 1.1a However I have some problems.
Using a laptop with a USB to 9pin serial adaptor connection.
Assigned COM1 to USB adaptor.
When I start the UFL it by default starts to look for COM1.
On selecting DOWNLOAD - I get a START button and on selecting this I get the following message:
"The receiver was not detected"
"If you want to download the firmware in the boot mode, click OK button below and AC power on your receiver"
COM Port settings:
COM1 COM2 COM3 COM4 (You can select one of these)
I again selected COM1 port.
then UFL displays a message 'Waiting response from Receiver...'
and nothing happened for Hours. :(
I have a Serial cable (F-type)) supplied with the box, so I have assumed it is a NULL modem cable. I hav einstalled all driver for USB-serial converter.
Help much appreciated.
Thanks
Using a laptop with a USB to 9pin serial adaptor connection.
Assigned COM1 to USB adaptor.
When I start the UFL it by default starts to look for COM1.
On selecting DOWNLOAD - I get a START button and on selecting this I get the following message:
"The receiver was not detected"
"If you want to download the firmware in the boot mode, click OK button below and AC power on your receiver"
COM Port settings:
COM1 COM2 COM3 COM4 (You can select one of these)
I again selected COM1 port.
then UFL displays a message 'Waiting response from Receiver...'
and nothing happened for Hours. :(
I have a Serial cable (F-type)) supplied with the box, so I have assumed it is a NULL modem cable. I hav einstalled all driver for USB-serial converter.
Help much appreciated.
Thanks