alex_r_2001
24th March, 2019, 06:38 AM
Hello family I have this tow truck that wont start I have error code
sid 0253 fmi=1 is ecu says something about not being able to write to eeprom or wrong calibration. Nobody has attempted to program so I do not get why it say wrong calibration.. Now my question is if this ecu has a bad eeprom including data is there anybody on this forum with any valid dump files for this ecu so I can test on bench... I have many eepro. And flash programmers available but I do not have any diagnostic software for this truck only thing I have that might have a communication protocol for this is my pass-thru. Any help would be appreciated....
All numbers on ecu are
Back Label
IE01114 s/n 0362743
Front label
Prg2pn03 230
183939368c2 5WY7194/03--
Customer did tell me that truck starts when codes are cleared but turns off in a couple of seconds once it registers fault then will not start again.
..
sid 0253 fmi=1 is ecu says something about not being able to write to eeprom or wrong calibration. Nobody has attempted to program so I do not get why it say wrong calibration.. Now my question is if this ecu has a bad eeprom including data is there anybody on this forum with any valid dump files for this ecu so I can test on bench... I have many eepro. And flash programmers available but I do not have any diagnostic software for this truck only thing I have that might have a communication protocol for this is my pass-thru. Any help would be appreciated....
All numbers on ecu are
Back Label
IE01114 s/n 0362743
Front label
Prg2pn03 230
183939368c2 5WY7194/03--
Customer did tell me that truck starts when codes are cleared but turns off in a couple of seconds once it registers fault then will not start again.
..