PDA

View Full Version : Security read/write ecu serial/bench



TeamSauroRacing
26th March, 2019, 10:32 PM
Hello dear, i'm not expert and i need a council.
i have mpps v 13 , gallo v 54 and ktag europe version. edit many ecu's without obd. now i remap an megane 1.5 110cv siemens sid 305 (this ecu is new for me). i have fear to broken this ecu in obd mode beacuse the car after smal time, switch off the dashboard.
i quietly read in obd this ecu (2mb file) but i do not trust to write obd. now my question is....
i have ori file (read obd 2mb) now i edit this file. in next time when the people go to me for install new software i can read with ktag (backup) and write only file (read obd 2 mb file tuning)?

Thank's Matteo

stilo115cv
26th March, 2019, 11:52 PM
Hi Matteo
if you read by obd, write by obd
if you read by bdm, jtag or boot, write in same mode.

The lenght of file is not equal in some case

for your case :

inserire marcia e dopo inserire scheda nell'alloggiamento

premere e tenere premuto il tasto di accensione fino a che il quadro non si accende e, comunque, passano almeno dieci secondi

in alcuni casi il quadro mostrerà la scritta ( togliere la card ) e comunque la card NON VA MAI ESTRATTA FINCHE' STAI OPERANDO

se non compare nulla, attendi almeno cinque minuti lasciando tutto così come è, vedrai che il quadro non si spegne.
Quando hai terminato la scrittura, premi ripetutamente il tasto accensione per spegnere il quadro.

Good luck

TeamSauroRacing
27th March, 2019, 08:19 PM
Hi Matteo
if you read by obd, write by obd
if you read by bdm, jtag or boot, write in same mode.

The lenght of file is not equal in some case

for your case :

inserire marcia e dopo inserire scheda nell'alloggiamento

premere e tenere premuto il tasto di accensione fino a che il quadro non si accende e, comunque, passano almeno dieci secondi

in alcuni casi il quadro mostrerà la scritta ( togliere la card ) e comunque la card NON VA MAI ESTRATTA FINCHE' STAI OPERANDO

se non compare nulla, attendi almeno cinque minuti lasciando tutto così come è, vedrai che il quadro non si spegne.
Quando hai terminato la scrittura, premi ripetutamente il tasto accensione per spegnere il quadro.

Good luck

thank's Stilo115cv!! i try in next time!
Grazie mille ancora!
Another question... this car i read and write with gallo v 54? i security write sid 305 with obd to galletto v54?

dariobmw
28th March, 2019, 01:25 PM
Normally if you read with a tool you kan rewrite with that too because for read the tool need to bypass the security
of the ecu , so in teory you shuld be able to rewrite that you hawe read.........