View Full Version : Reading/writing EDC16C31 Volvo
omglol
31st March, 2019, 06:34 PM
Hello,
I need to R/W EDC16C31 from Volvo with FGTech EU. Can anyone confirm this is working OK? My engine is 2.4D, but FGTech lists only 2.5 engine with this ECU?
Also, which pinout is correct? FGTech:
https://i.gyazo.com/4e8911f0832d033334418a025a5194a3.png
or this one?
http://uploads.tapatalk-cdn.com/20140125/yru5yda7.jpg
Thanks for help!
figani
31st March, 2019, 06:43 PM
I use the second one with IOTerminal... with Can/bus...
omglol
31st March, 2019, 06:48 PM
I don't have I/O Terminal, so I am only interested in solution with k-line using FGTech.
kaadzis
31st March, 2019, 07:54 PM
it works!! both. 1 2 3 ar positive ,2 4 6 are ground. for bench u can use just one + and one gnd. and ignition. so 1st picture will be more easy
omglol
31st March, 2019, 07:58 PM
it works!! both. 1 2 3 ar positive ,2 4 6 are ground. for bench u can use just one + and one gnd. and ignition. so 1st picture will be more easy
Thanks. You mean 1,3,5 are positive and 2,4,6 ground, right?
If I leave everything in car and just run a wire from pin 43 to obd pin 7, should also work, right?
SpecZ
31st March, 2019, 08:17 PM
Thanks. You mean 1,3,5 are positive and 2,4,6 ground, right?
If I leave everything in car and just run a wire from pin 43 to obd pin 7, should also work, right?
Yes normally works perfectly.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.