PDA

View Full Version : Ktag - The tool is not powered correctly error, is it dead?



amittalkin
17th April, 2019, 05:48 AM
My Ksuite 2.23 and 2.25 on Ktag clone showing me following error.

612872

"The tool is not powered correctly : Control power supply"

I tried stock 12v 1A power supply as well as new 12v 5A and other 15v 1.5A supply. same error on it. Is the tool dead or something?
Red LED is ON though. I don't want to send it back to seller as it will cost too much time and money. Any help?

Hexer84
17th April, 2019, 08:20 AM
Check PCB with Multimeter if 12v is supplied.

Maybe just the socket is bad.

Gesendet von meinem SNE-LX1 mit Tapatalk

raceshadow
17th April, 2019, 08:31 AM
My Ksuite 2.23 and 2.25 on Ktag clone showing me following error.

612872

"The tool is not powered correctly : Control power supply"

I tried stock 12v 1A power supply as well as new 12v 5A and other 15v 1.5A supply. same error on it. Is the tool dead or something?
Red LED is ON though. I don't want to send it back to seller as it will cost too much time and money. Any help?

For many ktag clones, there was a problem with poorly soldered NXP.

amittalkin
17th April, 2019, 10:20 AM
Thanks I will check PCB for any damaged or improper connections.
However it was working fine a day ago, but it was showing some other error " Control all connections". Now as I figured out it was problem at my end ( didnt plug GPT cable correctly ) . But then this new error came up.
I am just wondering if 12v 5A power supply was too much for it and it died?