5000
26th April, 2019, 07:32 PM
Hello!
Can someone help me please?
I have ST-Link V2 with the latest software and I connected it to 3 cdp+ boards and just read the flash memory. I havenīt do anything else, just read, save the file and disconnect, just to experiment the ST-Link. Now I canīt update the firmware neither with autocom, delphi or wow. It detect the tester, says that I need to update the firmware and give error. I had experimented the FLASH loader demonstrator to correct it but itīs the same. When I put the testers in boot mode, the red light only stays on for 5 seconds ang goes off. Also in boot mode the wow starts to update but not finish the second part of the firmware. I am trying all type of manuals, hundreds of shits, STM32Fxx manuals and nothing. The ST-Link broked all my testers :( Someone have any ideas?
Thanks
Can someone help me please?
I have ST-Link V2 with the latest software and I connected it to 3 cdp+ boards and just read the flash memory. I havenīt do anything else, just read, save the file and disconnect, just to experiment the ST-Link. Now I canīt update the firmware neither with autocom, delphi or wow. It detect the tester, says that I need to update the firmware and give error. I had experimented the FLASH loader demonstrator to correct it but itīs the same. When I put the testers in boot mode, the red light only stays on for 5 seconds ang goes off. Also in boot mode the wow starts to update but not finish the second part of the firmware. I am trying all type of manuals, hundreds of shits, STM32Fxx manuals and nothing. The ST-Link broked all my testers :( Someone have any ideas?
Thanks