Programming Land Rover Discovery 2 key with a Nanocom

[VicV]

I just received the LR key I ordered from China with programming barcode. I am trying to program the key with a Nanocom to a D2. I set the code “5007FA” but can’t seem to synchronise it, error message pops on Nanocom “No signal received” but when I change the code into “5007F9” then the key successfully synchronises but when I want to detect the key the green field doesn’t change in “DETECTED” and the key doesn’t work !! Any idea how to program this key ? Thanks

617424

[mustafabahar]

The code you can match with Mvp or smart pro but chip you must first make transponder Pcf7935 its ews box read chip code it


Verzonden vanaf mijn iPhone met Tapatalk

[P&D]

The code begins with N this is a rover remote
discovery remotes begin with G

[godfathertre]

i tought if was a genuine landrover remote would have the extra yellow box on circuit board there was a post on this forum about these remotes.

[godfathertre]

the yellow box on the remote tells you is a landrover remote this key is not a landrover remote better buy used as they can be reused


and there is a calculator on forum to help you and the barcode start with g as said on above posts.