Iveco daily 50c13 2.8L MS6.3

[jameshal18]

Hello DK friends. I tried to read bosch MS6.3 ecu from iveco daily with kess v2. i didnt have any adaptor for round iveco plug so i connected to pins 12v, ground and k-line. Kess was connected, took ID and made ecu reading also.
The thing is reading took only 5-6 seconds and message "reading ecu finished successfully" popped up.

File is 512 KB. Will post it later.

Any experience with such ecus? Any way of full bdm back up?

Kind regards.

[jameshal18]

Hello DK friends. I tried to read bosch MS6.3 ecu from iveco daily with kess v2. i didnt have any adaptor for round iveco plug so i connected to pins 12v, ground and k-line. Kess was connected, took ID and made ecu reading also.
The thing is reading took only 5-6 seconds and message "reading ecu finished successfully" popped up.

File is 512 KB. Will post it later.

Any experience with such ecus? Any way of full bdm back up?

Kind regards.

This is the file readed. is it correct?

621890

[mario38]

This is the file readed. is it correct?

621890

yes the reading of the file is correct

[jameshal18]

Anyone can tell if it is original? if yes, i will need a stage 1 tune. I dont have the definitions for this ecu.

[dominik.m]

Here. Your file mod. Test and r.......

[jameshal18]

Thanks Dominik. Will test and report.

Kind regards.