kia sorento remote control synchronizing?

[cartech]

hello all!
any body can give me the procedure to synchronize all models of remote control for kia sorento.
http://ecx.images-amazon.com/images/I/51uf7CG2Q3L._SL500_AA250_.gif

[f_alarms]

urn on ignition to ON.
Push LOCK button on all remotes TWO times.
Turn off ignition
Test remotes - they should work. :barscarf:

[Mister Mint]

2005 Kia Serento
This is what you will need to have before you start
?1 or 2 OEM Key Fobs.

?1.5 foot of electrical wire, with ends stripped,
approximately 22 gauge. (Jumper Wire).


Steps:
?Open the hood of your SUV.


?Behind the battery on the drivers side is a plastic covered connector labeled Diagnostics.


?Open the plastic cover on the Diagnostics port by pulling up on the edge near the FRONT of the vehicle.
?Get your prepped/stripped jumper wire and place one end in connector 6 as shown in the pictures.


?Run the other end of the jumper wire to the POSITIVE terminal on your battery, you can just push it into the little opening on there so it stays in place for a few minutes.


?Get into your vehicle with your key fobs.
?Put one key into your ignition and turn to ON position, DO NOT start your vehicle.
?If you just have ONE key fob to reprogram, when you turn the vehicle to ON, hold the LOCK button down for 3 seconds, the lights on the dash will go off, and you are done. Turn the key off, disconnect the wire, and try the key fob.
?If you have TWO key fobs to reprogram, turn the key to ON, hold the first LOCK button for 1 second, then the second one for 1 second. Turn the key off after the lights on the dash go off and remove the jumper wire. Test both Key Fobs

Programming keyfob
:sheep:

----------------------------------------------------------http://www.digital-kaos.co.uk/forums/images/styles/digital/attach/bz2.gif bz2488.3 KB---------------------http://www.digital-kaos.co.uk/forums/images/styles/digital/attach/bz2.gif bz2488.3 KB--http://www.digital-kaos.co.uk/forums/images/styles/digital/attach/bz2.gif bz2488.3 KB--

[foxdata]

plz how huyndai starex remote control synchronizing
2005-2007
or up

[Digitalmotor]

this way never work

[shitad]

2005 Kia Serento
This is what you will need to have before you start
***8226;1 or 2 OEM Key Fobs.

***8226;1.5 foot of electrical wire, with ends stripped,
approximately 22 gauge. (Jumper Wire).


Steps:
***8226;Open the hood of your SUV.


***8226;Behind the battery on the drivers side is a plastic covered connector labeled Diagnostics.


***8226;Open the plastic cover on the Diagnostics port by pulling up on the edge near the FRONT of the vehicle.
***8226;Get your prepped/stripped jumper wire and place one end in connector 6 as shown in the pictures.


***8226;Run the other end of the jumper wire to the POSITIVE terminal on your battery, you can just push it into the little opening on there so it stays in place for a few minutes.


***8226;Get into your vehicle with your key fobs.
***8226;Put one key into your ignition and turn to ON position, DO NOT start your vehicle.
***8226;If you just have ONE key fob to reprogram, when you turn the vehicle to ON, hold the LOCK button down for 3 seconds, the lights on the dash will go off, and you are done. Turn the key off, disconnect the wire, and try the key fob.
***8226;If you have TWO key fobs to reprogram, turn the key to ON, hold the first LOCK button for 1 second, then the second one for 1 second. Turn the key off after the lights on the dash go off and remove the jumper wire. Test both Key Fobs

Programming keyfob
:sheep:

----------------------------------------------------------http://www.digital-kaos.co.uk/forums/images/styles/digital/attach/bz2.gif bz2488.3 KB---------------------http://www.digital-kaos.co.uk/forums/images/styles/digital/attach/bz2.gif bz2488.3 KB--http://www.digital-kaos.co.uk/forums/images/styles/digital/attach/bz2.gif bz2488.3 KB--

I can confirm that this method works 100% for 2005 Sorento I did one 2 days ago after I googled and found the exact doc.

[Digitalmotor]

I had try with info of (Mister Mint (http://www.digital-kaos.co.uk/forums/members/234750-mister-mint/)
) with serento
when i trun ignition on emergency light is stanby ,but when i press remote dont work