PDA

View Full Version : Opel Vivaro EDC16C36 P0089



Richarde46
6th June, 2019, 10:02 AM
Hi, New to this forum. So Hi to evryone :)

I'm currently working on a opel vivaro 2.5 With an edc16C36 which was chiptuned the wrong way . so it lost injector coding

Now i have coded the injectors with Delphi , acording to the numbers that are shown on the injectors in the engine bay. now that works fine, the ecu stores the injector codes But still it will only crank and not start. it starts for a few secs and than dies off again , and with that the code P0089 is stored. So the fuel pressure is to high,

Do i need to recode the fuel pressure sensor also ? I have read about this, but i don't have Renault Can Clip.

original file is attached

Hope someone can help
gr richard

morgano
6th June, 2019, 10:25 AM
For p0089 i would start by replacing fuel filter.

Richarde46
6th June, 2019, 02:37 PM
The fuel filter on the car is new, and before any OBD actions the car ran fine.. so that's not likely to be the problem

morgano
6th June, 2019, 04:17 PM
Upload original file to ecu and see if problem persist.

Richarde46
6th June, 2019, 06:36 PM
Allready tried that, Same problem.

Novik_UA
6th June, 2019, 08:14 PM
With Can Clip in repair menu choose right high pressure pomp type, for sure if injectors codes lost, it lost too.