FIAT PUNTO EVO 1,3 MJD

[draganelektricar]

hello.
can remammp on this engine.
dpf off, egr off.

fiat punto evo 1,3mjd
HARDWARE NUMBER : MJ8DFHW00P
SOFTWARE NUMBER : 9743G485

HOMOLOGATION NUMBER : 8F2.G4

[Lambda1]

test, report, magic.
Thanks

[draganelektricar]

OK.
thanks.
perfect :encouragement:

[AVDigitale]

contact if needed

[gizgiz]

Hi dragneltricar , can you you tell what tool you're using ?
I have a fiat fiorino van 1.3 jtdm 2010 , I bought an MPPs v6 clone from ebay, somehow the write button is greyed out. I'm sending back.

Hardware number: MJD6F3HW04P
software number : 3549H196
Homologation number : 6F3.H1
Its a 75 HP , I'm looking in bumping it up to 95 HP and a bit more torque.
Thanks

[jameshal18]

Hi dragneltricar , can you you tell what tool you're using ?
I have a fiat fiorino van 1.3 jtdm 2010 , I bought an MPPs v6 clone from ebay, somehow the write button is greyed out. I'm sending back.

Hardware number: MJD6F3HW04P
software number : 3549H196
Homologation number : 6F3.H1
Its a 75 HP , I'm looking in bumping it up to 95 HP and a bit more torque.
Thanks

A good tool for such car is Kess V2.

[gizgiz]

Thanks jameshal 18 , will a kess v2 from eBay that is around £53 any good , I think it has a red circuit board ( read and write via obd port ? ).

[Lambda1]

Clones are never as good... if clone use EU Clone, think purple board... but they arent on ebay and also arent for 50 bucks :d

[jameshal18]

Thanks jameshal 18 , will a kess v2 from eBay that is around £53 any good , I think it has a red circuit board ( read and write via obd port ? ).

I have bought many from obdexpress.co.uk and work with no problem. but for sure arent good as the original.

[Panathaole]

kess maybe can't read that ecu, check before buy......... better use ktag or galletto for bdm reading in any case.... and mpps can do via obd too.....

[jameshal18]

kess maybe can't read that ecu, check before buy......... better use ktag or galletto for bdm reading in any case.... and mpps can do via obd too.....

I recently made read-write in such car with kess v2. checksum ok also.

[Panathaole]

i try once in a fiat 6f3 and get virtual reading..... kess v2.27 if i remember correct.....

[draganelektricar]

hello.
I was absent.
I use ioterminal.
reads and writes without any flaw.

[adriani1978]

HY
can verify if this file is dpf off ok
thanks