bmw dme mevd1724 2014 BMW4

[dd1]

HI ALL, i just replaced a dme on this bmw. used, i mirrored the vin isn etc with bmw, ECU explorer. the car started fine. but give me check engine errors, fault codes. and has lose of power. idle is fine. can you guys guide me with this problem???

[rafal]

before change dme was all ok ?

[clauberty]

You must code with e sys and after will have right vin and coding

If you do not know how let me know, remote and one minute problem solved

Sent from my PLK-AL10 using Tapatalk

[dd1]

You must code with e sys and after will have right vin and coding

If you do not know how let me know, remote and one minute problem solved

Sent from my PLK-AL10 using Tapatalk

Ok, I like that, give me some hints on this

[dd1]

before change dme was all ok ?

the original dme had error codes that couldn't be cleared. I transferred the vin, Isn, motor hour and checked everything again. I scanned it and it comes up with the correct vin

[clauberty]

do you have e sys installed and e-net interface?

[clauberty]

the original dme had error codes that couldn't be cleared. I transferred the vin, Isn, motor hour and checked everything again. I scanned it and it comes up with the correct vin
what error codes? eeprom related?

[dd1]

do you have e sys installed and e-net interface?
Yes and the flash files with it

[dd1]

what error codes? eeprom related?
The original dme had waste gate codes and some other sensor related that wouldn't clear. The used one I installed I copied all the info and transferred to it. It shows the original car vin, starts but power is low when driving

[clauberty]

Yes and the flash files with it
then perform coding

[dd1]

I have done some minor codings, not a dme. Any ideas how and what to do? Thank you in advance

[dd1]

do you have e sys installed and e-net interface?
Hi, do you think you can help me out with this? I kind of tried to do it but no luck?

[clauberty]

Hi, do you think you can help me out with this? I kind of tried to do it but no luck?On Monday after 6

Sent from my PLK-AL10 using Tapatalk

[dd1]

Ok, write me here or email it so that I know, thnx

[dd1]

monday has passed. anyone can help me????????

[tomvleeuwen]

Try to delete adaptations and thought versions first. BMW Explorer should be able to code the ECU as well but usually there is not much that can be coded in the ECU.

[Levanime]

you needed to clone it, would be easiest and safest.

you have wrong power class, you can reset working hours and then code it correctly.

[dd1]

you needed to clone it, would be easiest and safest.

you have wrong power class, you can reset working hours and then code it correctly.
reset working hours? Like zero it?

[dd1]

you needed to clone it, would be easiest and safest.

you have wrong power class, you can reset working hours and then code it correctly.
What TOOL clones these units? I have used the ecu explorer to mirror the info from original to used.

[dd1]

hi everyone, trying to code it with esys, when calculating tal calculation, an error pops up.