Read out Bosch MED17.1 via OBD? or Bench?

[Trice1001]

Hey guys i want to read out my Med 9.1 from my audi 2.0tfsi so i opened the ecu and i see the Port for BDM ist Break up :mad-new: two pads losed

I have tried to read out with kess via OBD kess say ID wrong :( then i have tried via Bench kess says me error when calling or everithing.
Can i read somehow via OBD oder Bench?

Thanks a lot

ITS MED9.1 Sorry!

[figani]

Post a good photo from bdm port...

[Trice1001]

du you will not see it :D

Give it alternativ points on the bord to solder cable on to read out?

[Trice1001]

Hi,

A Pic.

The BDM port was overtaped with isolation band, but good work from outside i have no see that was sometime open. :(

i Need alternativ Points to solder wire to Read out or any.

[figani]

you started with MED17, then in post you wrote med9...

it looks like med9...

the crossed one in my picture you don´t need with ktag/trasdata...
but don´t know which tool you use...

and it will be easier, if you could make a better (clear) photo...
from this part where the arrow is...