workshop bot
21st June, 2019, 06:18 PM
Hello forum,
I read a Bosch H6.2 ECM with Ktag clone. It gives reading successfully completed at the end, but when I save the file I get a checksum error. If I attempt to write the file with the checksum error, it will proceed with writing.
I read a Bosch HK.2 and it saves correctly with no checksum error. I have also read a Bosch ME7.1 with no checksum problem. This makes me think computer settings are ok.
I see the H6.2 is 257 KB, while the HK.2 is 260 KB. Could someone explain possibilities why I am getting a checksum error? Would it matter if I install the file into a donor ECM with the checksum error? Could it be a problem
with the processor? It is a AM29F800BB processor in both the H6.2 and HK.2 ECM.
Thank you for reading.
Bryan
I read a Bosch H6.2 ECM with Ktag clone. It gives reading successfully completed at the end, but when I save the file I get a checksum error. If I attempt to write the file with the checksum error, it will proceed with writing.
I read a Bosch HK.2 and it saves correctly with no checksum error. I have also read a Bosch ME7.1 with no checksum problem. This makes me think computer settings are ok.
I see the H6.2 is 257 KB, while the HK.2 is 260 KB. Could someone explain possibilities why I am getting a checksum error? Would it matter if I install the file into a donor ECM with the checksum error? Could it be a problem
with the processor? It is a AM29F800BB processor in both the H6.2 and HK.2 ECM.
Thank you for reading.
Bryan