Xentry passthru doubt

[morgano]

Hi.

Was wondering if it is possible diagnose and coding old kline control units like bas-esp from g 270 (463.322) with the xentry passthru and a tactrix openport 2.0

Is there any trick to make it work on old kline units?

I can only connect with engine ecu and i guess it is CAN.

Trying to connect to bas-esp unit give a fault “cannot change multiplexor mode” or something similar.

Is possible or not?

Ps: tried also with ford vcm2 and exactly same result as with tactrix.

Thanks

[mexanico1971]

Hi.

Was wondering if it is possible diagnose and coding old kline control units like bas-esp from g 270 (463.322) with the xentry passthru and a tactrix openport 2.0

Is there any trick to make it work on old kline units?

I can only connect with engine ecu and i guess it is CAN.

Trying to connect to bas-esp unit give a fault “cannot change multiplexor mode” or something similar.

Is possible or not?

Ps: tried also with ford vcm2 and exactly same result as with tactrix.

Thanks

Hi
For what I read no, but I never try !
What passthru version are you using width VCM2 ?
What system ?

best regards

[morgano]

Hi
For what I read no, but I never try !
What passthru version are you using width VCM2 ?
What system ?

best regards


Installed Xentry Diagnostics PassThru OpenShell 2018-12 on a Win7 Professional X64, the VCM2 passthru drivers got installed when install main packet, i just plugged it
and was recognised as valid pssthru device. For the openport i installed drivers from tactrix page.

I read somewhere that one person had access to all units with a mongoose in passthru mode, or at least was what i understtod when i read. So that made me think that maybe there is a software trick to enable K-line modes in passthru, not just CAN.

Thanks for answering ;)

[morgano]

Anyone else have some other clue regarding this?

[Dboyd2374]

Anyone else have some other clue regarding this?

For older vehicles and programming that requires hhtwin it has to be installed on a 32 bit machine. If installed on a 64bit you can only do diagnostics etc but no programming, apparently there is a workaround but have to install 32bit on a virtual machine and the copy files but not tried it

[morgano]

You know what files need be copied?

[mexanico1971]

HI
I search and found that work width HHTWin12.2015