IFS.ServicesImplementation.rar

[mzakoor1141]

Hello friends, I have a question about battery voltage while using ISTA-P.I know its necessary to put external power supply while doing coding/programming.I have a modded server power supply which outputs 13.2V-80 Amps.When i connected ISTA-P to my E70 using ICOM with external power supply connected,both kl15 and 30 shows 12.9~13 volts and ISTA-P threshold is min 13V.Then i physically checked voltage at the charging terminal in the engine compartment with fluke multi-meter,it reads 13.2 volts.But my ICOM reads 13Volts.Means ICOM is reading .2 volts less than the actual battery voltage at the charging terminal.I know my Fluke multi-meter is quite precise.Any way to calibrate the icom?Ista-P ends the session because it senses voltage lower than 13V.Any suggestions please?Thanks









so Im locking for IFS.ServicesImplementation.rar if its possible that could somebody please help me and upload it here
thanks in advanced