PDA

View Full Version : MB edc15c6 popcorn limiter?



mb270cdi
8th August, 2019, 03:06 PM
Hi!

Do I have to put the popcorn limiter on the torque limiter or driver wish?

Map addres?? help!

golf110tdi
8th August, 2019, 03:21 PM
No matter where you put popcorn limiter, it's matter how will you do it to get maximum hard cut.

mb270cdi
8th August, 2019, 03:41 PM
yes but i am not sure if the torque limiter map is correct 163A8


Sorry my bad english

golf110tdi
8th August, 2019, 03:48 PM
Upload your file.

mb270cdi
8th August, 2019, 04:02 PM
can you put a hardcut here file?

a500tut
8th August, 2019, 04:27 PM
can you put a hardcut here file?

Hi, thanks and rep!

mb270cdi
8th August, 2019, 05:45 PM
did not pop or change really anything, can you make a better one?

golf110tdi
8th August, 2019, 06:36 PM
Ok. Now I write from my phone. Tomorrow I will help you.

alfanacleto
8th August, 2019, 08:54 PM
hard cut of this ecu its by torque limiter no??
which codeblock its active??
dont touch rail pressure maps??
at least to 1450 bar

mb270cdi
8th August, 2019, 09:11 PM
I put the torque limiter 4501 in the first position.


the torque limiter map is 163A8
Hope it is the right map (automatic)

mb270cdi
8th August, 2019, 09:12 PM
what a codeblock??

a500tut
8th August, 2019, 09:26 PM
I put torque limiter on 4400 rpms. You really test this on the car at speed? :)

mb270cdi
8th August, 2019, 09:32 PM
I do not understand:biggrin:


some small bang was noticeable.

Sorry my bad english.

golf110tdi
8th August, 2019, 09:40 PM
Put in every block, popcorn in torque map.

a500tut
8th August, 2019, 09:59 PM
Try this and report! ;)

mb270cdi
9th August, 2019, 09:34 AM
Thanks!
the software is working now but what map you were editing as rpm could be reduced

mb270cdi
9th August, 2019, 09:35 AM
about 4000rpm

a500tut
9th August, 2019, 11:10 AM
about 4000rpm

Try and report!

JoeTe
25th March, 2020, 11:10 AM
Try and report!


Hi friend, could you put a hard cut in this file at 4400 rpm? The car is automatic so If it do it at neutral is enough for me

Of course I give thanks and reputation!

naskochipa
25th March, 2020, 12:08 PM
Hi friend, could you put a hard cut in this file at 4400 rpm? The car is automatic so If it do it at neutral is enough for me

Of course I give thanks and reputation!

Thanks and Reputation = Pass

Pass-PM

Test and Report

Uhrintamas1234
29th June, 2023, 10:27 PM
Próbáld meg és jelentsd!
password ??

Uhrintamas1234
29th June, 2023, 10:28 PM
[QUOTE=a500tut;3643340]Próbálja ki és jelentse! ;)[/IDÉZET]
password ???