View Full Version : ford focus 2007 dash board change to other
sarunasgr
9th August, 2019, 09:53 AM
Hello ,
I have ford focus 2007 and want change dash 1K78X to 1M80F , can some add keys from old 1K78X to new 1M80F and sync with engine Thanks!641869641870
sarunasgr
9th August, 2019, 01:58 PM
dash old and new641934641935
jomberykaso
9th August, 2019, 02:27 PM
Test and report
sarunasgr
9th August, 2019, 06:58 PM
not works car not start ,I see dump and find only change vin, need add keys from old dash to new and sync ID code ,pleasae!
add full dash eprom and flash 642031
jomberykaso
9th August, 2019, 08:09 PM
i will not do that for free, maybe someone more can do this for funny....
narkeleptk
9th August, 2019, 08:15 PM
here is old vin,key 1, key2 and crypto to new 1m80f. I'm to lazy to do mileage. If there is any other codes needed to work I do not know.
I believe the cluster your trying to use is for a later model... Will it even work with out issue?
sarunasgr
12th August, 2019, 06:24 AM
hello,
I try again , but still not start car , in the dash found fault code , key not programmed, I think need sync code dash with engine ECU .....
sarunasgr
12th August, 2019, 06:50 AM
dash with 1K78X is europe milepage is KM/H , dash 1M80F is from UK milepage is MPH
sarunasgr
12th August, 2019, 06:53 AM
B1601 PATS(Passive Anti Theft System) Received Incorrect KeyCode From Ignition Transponder.--Possible Causes--- Non-Programmed Key Being Used
kiszka
12th August, 2019, 09:34 AM
B1601 PATS(Passive Anti Theft System) Received Incorrect KeyCode From Ignition Transponder.--Possible Causes--- Non-Programmed Key Being Used
which keys do you have, read key page 3
old dash km is 184341
sarunasgr
12th August, 2019, 10:21 AM
I have orginal ford focus key , I think is first key
narkeleptk
12th August, 2019, 12:56 PM
Do you have any tools to read key id like Kiszka suggests?
the original file had 3 key id's in it. The donor only had 2 so I just copied 2 over for simplicity. you must have the 3rd key id that i did not add.
try this file, I have added key 3 from original in.
If you get a solid light then that means you need to do parameter reset. If you can not do this by obd then you can read the eeprom in ecu and post it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.