Peugeot 306 Keypad

[nezocas]

Hi,

Custumer forgot code from Keypad.

Ecu is:

Magneti Marelli
G6.14 0D03
9624999980
16223.134

Inside we have:

MC68HCP11A1VFN mask F92J
flash I am not sure .... sticker delleted the numbers on it.

Wich chip do I need to read to get the correct pin to start the car and after disconnect the keypad.

Regards

[rch11]

Read motorola

[nezocas]

Hi,

Here are 2 dump´s.... one is only from eeprom part of MCU.... and the other is the full read of MCU

[nezocas]

Hi,

Anyone can give me the code to enter in the Keypad.

Best regards
Nezocas

[gobe]

try this ...without keypad

[nezocas]

try this ...without keypad

Will report back to you

Thank´s

[nezocas]

try this ...without keypad

Worked first time....!!!!!

Best regards
Nezocas

[icar]

hi folks,
i need immo off of Peugeot 406 96y 1,6 benz
ecu is IAW8P.14
mcu. motorolla HCP11A1
i tried with immokiler but not works, with ignition on pump is on until switch ignition off, no spark, no injection
any help will be appreciate

[nsl1]

What programmer can be considered motorolla HCP11A1? Can this be done without soldering the microcircuit? thank

[Bllinda]

Press both buttons


hi folks,
i need immo off of Peugeot 406 96y 1,6 benz
ecu is IAW8P.14
mcu. motorolla HCP11A1
i tried with immokiler but not works, with ignition on pump is on until switch ignition off, no spark, no injection
any help will be appreciate

[icar]

What programmer can be considered motorolla HCP11A1? Can this be done without soldering the microcircuit? thank

UPA read in circuit just lift reset and modb

[icar]

Bllinda Thank you for your attention but i need immo off of this file not pin code, or pass. for gobe file becauce i tried 2 immo off files and car not start

[Bllinda]

Here you will find something to lift

[gobe]

------off------

[furnata]

gobe- can you help please
https://www.digital-kaos.co.uk/forums/showthread.php/914508-Citroen-ZX-1-4i-Magnet-Marelli-G6-14-0D03-immo-off-please

[gobe]

send the dump !