View Full Version : Seat leon fr 184cv edc17c64
alfanacleto
7th September, 2019, 06:36 PM
Hi, today I try to read this ecu with ktag clone but I can't do it, someone do this ecu with clon by boot??
I need the pin out please for ktag 7.020 or kess 5.017
Thanks
alfanacleto
7th September, 2019, 09:16 PM
Nobody??
Please help
bazaa
8th September, 2019, 08:56 AM
Yes it is possible to read edc17c64 with kess and ktag clones the boot pin is shown correctly in the software ,what problem are you having most are due to poor boot pin connection or power supply current to low ,ie use better power supply .
alfanacleto
8th September, 2019, 09:24 AM
Yes it is possible to read edc17c64 with kess and ktag clones the boot pin is shown correctly in the software ,what problem are you having most are due to poor boot pin connection or power supply current to low ,ie use better power supply .
Power supply of??
14v 2A?
bazaa
8th September, 2019, 09:30 AM
That power supply should be fine
alfanacleto
8th September, 2019, 09:56 AM
That power supply should be fine
This diagram its for a gpt cable?
In my diagram need 2 c
alfanacleto
8th September, 2019, 10:19 AM
Quick look, this boot it's for a 1797 and my chip it's 1793
a500tut
8th September, 2019, 10:41 AM
Quick look, this boot it's for a 1797 and my chip it's 1793
Try this solution.
649034
alfanacleto
8th September, 2019, 10:59 AM
Try this solution.
649034
Need to connect 2.2k to the cables??
I always connect boot pin with pen probes, then, need to connect the 2.2k to the pen probe?
raceshadow
8th September, 2019, 11:27 AM
https://wiki.obdtuning.de/images/c/ca/VAG_EDC17C64_Boot_pin.jpg
a500tut
8th September, 2019, 11:34 AM
Need to connect 2.2k to the cables??
I always connect boot pin with pen probes, then, need to connect the 2.2k to the pen probe?
You need check cable for resistance, maybe it have 2.2k, if not, then add it :)
For read password dont connect boot pin, for read/write connect boot pin with 2.2kOhm to GND(-12V).
alfanacleto
8th September, 2019, 12:03 PM
https://wiki.obdtuning.de/images/c/ca/VAG_EDC17C64_Boot_pin.jpg
My chip it's 1793
daniel guerra
9th September, 2019, 09:59 PM
Hi, today I try to read this ecu with ktag clone but I can't do it, someone do this ecu with clon by boot??
I need the pin out please for ktag 7.020 or kess 5.017
Thanks
I did it KTAG 7.020 with GTP cable, just need to follow the instructions.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.