View Full Version : 2015 Toyota Prado
trinicolin
11th September, 2019, 04:02 PM
Hi guys I am having no tacho and speedo needle movement after mileage correction. Odo counter is adding but no needle movement. Any suggestions?
Sent from my SM-G930F using Tapatalk
clusters
11th September, 2019, 04:05 PM
Put the original file back and see if that cures it.
If it does post the original here for proper correction.
trinicolin
11th September, 2019, 04:07 PM
Put the original file back and see if that cures it.
If it does post the original here for proper correction.Would test and report.
Sent from my SM-G930F using Tapatalk
trinicolin
11th September, 2019, 04:23 PM
Seems as though big trouble. Not even getting ODO reading now.
Sent from my SM-G930F using Tapatalk
clusters
11th September, 2019, 04:24 PM
If in circuit, remove it to program.
If unsoldered, check soldering or possibly overheated the chip. :dontknow:
trinicolin
11th September, 2019, 04:32 PM
I believed is overheated chip. I removed it many times. Do I need to replace it of something can be done to revive it?
Sent from my SM-G930F using Tapatalk
Cllau
11th September, 2019, 07:19 PM
I believed is overheated chip. I removed it many times. Do I need to replace it of something can be done to revive it?
Sent from my SM-G930F using Tapatalk
then take a new cip and write ori dump on it...:captain: also check your soldering..
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.