PDA

View Full Version : Looking for SMART 453 - D70F3536 DATA


CARPARTS
13th September, 2019, 07:11 PM
HI

I have SMART 453 - BRABUS from 2018

Dash has part-number : "248210877R" / its with TFT-color screen

I need full flash for the D70F3536

when you read the dash by OBD, it is saved as "SMARTV850_000" ; using for example DP4 as tool.

Would be nice if someone have this data...

Thx in advance
jjrp255630
17th September, 2019, 11:05 AM
hi, have you find it? im loking too
CARPARTS
17th September, 2019, 01:22 PM
hi, have you find it? im loking too

no, not yet...

otherwise a new dash cost about 500€...
jjrp255630
17th September, 2019, 02:21 PM
no, not yet...

otherwise a new dash cost about 500€...

what happend with your dash?

have your dumps to check is is like mine?
CARPARTS
17th September, 2019, 09:00 PM
Before writing any value, DP4 does first make automatic a reading from flash, and save it on the SD-card.

after this, the dash didn't work anymore

attach the "wrong" data
Steve182
2nd November, 2020, 05:09 PM
Hi, I need exactly the same flash for a smart 453 TFT color... if someone have a good backup (Dp4, smok, Dsp3+) it will be appreciated
tech_cz
5th November, 2020, 11:34 AM
If you wanna try...
Smok backup.

WBR, Marek
Haker5
19th March, 2021, 11:19 PM
backup make obd or you reading by jtag if yes you can share pinout
albdiag
11th January, 2023, 06:50 PM
If you wanna try...
Smok backup.

WBR, Marek

Hi

I have same problem

I did read flash with smok and i have same file as you
After i try to calibrate dash with smok it did write other flash and dash dead.

Now i try to write backup flash and smok say wrong file size

Any idea?

Thx
Cardiag.ru
11th January, 2023, 07:20 PM
Only a flash from 70F3536 will not help. Before writing the flash of 70F3536 over obd2, the erase command is used, which erases not only the 70F3536 flash, but also the external BGA graphics flash.
You can try use recovery in DP4 or IprogPro.
albdiag
12th January, 2023, 02:34 PM
Thx or the info.

I did try to read D70F3536 with vvdiprog but when pres read id the tool detected shortcut. Now loks like mcu is dead.
Maybe vvdi killed it
VCC-gnd looks in short - 10 ohm
bearheroes
28th December, 2023, 08:43 AM
Thx or the info.

I did try to read D70F3536 with vvdiprog but when pres read id the tool detected shortcut. Now loks like mcu is dead.
Maybe vvdi killed it
VCC-gnd looks in short - 10 ohm
hi. Do you have pinout?