View Full Version : Bosch MED 17.5.5 tsi micro protection removal failed
alfanacleto
21st September, 2019, 03:06 PM
Hi friends,today y tried to read this ecu with clone ktag 7.020 and the screen show this message
micro protection removal failed,the car its a seat ibuza 1.4 tsi 2011,can clone read it or not??,conectin diaghramp of ktag are ok?
figani
21st September, 2019, 06:08 PM
Hi friends,today y tried to read this ecu with clone ktag 7.020 and the screen show this message
micro protection removal failed,the car its a seat ibuza 1.4 tsi 2011,can clone read it or not??,conectin diaghramp of ktag are ok?
post a good picture of your pcb...
and a picture of your choosen protocol...
alfanacleto
21st September, 2019, 06:52 PM
652554
Main board
alfanacleto
21st September, 2019, 06:57 PM
652555
Conection diaghram
marcobh5
21st September, 2019, 08:06 PM
3 protocol for this ecu tricore for tprot under v7. Tricore tprot for tprot 8 to 10. And tricore gpt for tprot v11 what protocol you have try? If 2011 i think tprot v8 or v11
alfanacleto
21st September, 2019, 08:24 PM
Protocol 128
alfanacleto
21st September, 2019, 08:28 PM
652576
This protocol
Summa
21st September, 2019, 09:40 PM
Try to use a different tool ... , like an original tool perhaps ? :)
alfanacleto
21st September, 2019, 11:54 PM
Try to use a different tool ... , like an original tool perhaps ? :)
I see.... have you got one for a good price?
Are you a alientech seller?
Summa
22nd September, 2019, 08:12 AM
No , i do not sell, and there is not only Alientech that can do this ECU , i'm just saying should use original tools if you want the job done safety, you don't have to bee perky.
gas43
22nd September, 2019, 12:46 PM
Maybe like this? https://www.youtube.com/watch?v=rQe3MjL5Pvg
And take a look here at 15:00 https://www.youtube.com/watch?v=uTKgwz6EszI (https://www.youtube.com/watch?v=rQe3MjL5Pvg)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.