PDA

View Full Version : VAG EDC15V 24C02 without desoldering - possible or not?


vpiotraz
26th September, 2019, 09:09 AM
Hello
Is it possible to read/write 24c02 in EDC15V ecu (vag 1.9tdi with high/low memory) without desoldering? I tried with soic8 clip and it doesn't work (overcurrent message on TL866plus). Am I doing something wrong or is it impossible? After desoldering clip works fine.
Dimpo
26th September, 2019, 12:13 PM
Hi, i think better way to remove it.
galiza
26th September, 2019, 03:45 PM
I think Vag Can Commander 2.5 and a KKL line interface can do the job though OBD
vpiotraz
26th September, 2019, 06:20 PM
Tried with 3.6 and doesn't work - it's 80pin edc15v (looks like msa15 inside?) and doesn't support k-Line flash.
brend
26th September, 2019, 06:24 PM
You have 2 sulutions in your situation.
1.Just not to do nothing ,thats all.
2.If you want to do this job ,so......desolder,read and load dump!!!!




Tried with 3.6 and doesn't work - it's 80pin edc15v (looks like msa15 inside?) and doesn't support k-Line flash.


Hello
Is it possible to read/write 24c02 in EDC15V ecu (vag 1.9tdi with high/low memory) without desoldering? I tried with soic8 clip and it doesn't work (overcurrent message on TL866plus). Am I doing something wrong or is it impossible? After desoldering clip works fine.